top of page
IMG_20171226_192957_758.jpg

Teaching

My interest for teaching and spreading my knowledge began during my Engineering and it was majorly because of my mentor - Dr. Chakravarthula Kiran. I have always considered myself a good orator who can connect well with people, but I never realized that I could use these qualities to help people learn. Dr. Kiran helped me bridge this gap and gave me several opportunities to teach other students or sometimes, even teach him about something new. This encouragement led me to teach in a workshop during the college's annual technical symposium in my 2nd year of Engineering. From then on, I have conducted several workshops to teach few technologies to students. This interest soon turned into a source of income. 

​

In my opinion, teaching not only helps you spread knowledge but also helps you in gaining more and also gives you a sense of satisfaction. These incentives keep me motivated to learn and teach on a continuous basis. I hope to continue to add value and improve the thought process of students through my classes.

IMG-20190926-WA0007.jpg

INTRODUCTION TO MATLAB PROGRAMMING

My team and I organized a short workshop for students to get started with MATLAB programming. The course gave a brief introduction to the variety of applications MATLAB is used in, helped students get acquainted with the syntax and also gave a brief introduction to Image Processing  

IMG_20181013_204316.jpg

PCB DESIGNING USING AUTODESK EAGLE 

This course aimed at helping students to get started with Printed Circuit Board Designing and Fabrication (using Toner Transfer Method). After this course, students were equipped with the knowledge and skill to design, fabricate and test single-layer PCBs. 

IMG_20181015_210120_289.jpg

ARDUINO 

PROGRAMMING - ADVANCED 

This course was built upon a beginner level course, which aimed at helping student understand Embedded System Development using Arduino. The students learnt how to write simple libraries, interfaced several components and worked with interrupts. 

IMG_20181006_152949.jpg

ARDUINO 

PROGRAMMING - BEGINNER 

This was a beginner level course designed to get students acclimates to Arduino and basic concepts of Electronics. The students learnt about the hardware architecture, the IDE, basics about sensors and communication protocols.  

bottom of page